I would like to be able to manually operate the light for when I need it to stay on continuously, and then have it operate on the motion sensor when I am away from it. Basically I have a motion sensor light mounted above the entrance to my shed/ workshop, and sometimes I need to set up my sawhorses outside of the shop to do work at night and the light is sufficient, but when I have been still too long, perhaps doing some figuring or whatever, it goes out. I don't want to have to continue to wave my hands about to get it to come on every time it goes off. Do I need a double pole single throw switch, or a single pole double throw, or what(is a three way light switch a SPDT- [single pole double throw] switch)? Is there a way to wire it to a single switch where I could flip it over to one side to operate continuously, and then flip the switch to make the light work off of the motion sensor when I have gone in for the night? Please forgive the ignorance. I just can't envision it in my head. Thanks.
![Intelectron Security Light Manual Intelectron Security Light Manual](/uploads/1/2/5/8/125871579/573338863.jpg)
Detector Security Light Manual free downloads - How to Repair a Troy-Bilt TB20CS Weed Eater Pull Cord Home, Power Electronics By P S. Hotwheelsmatchboxroadsplatset ITEM: You are bidding on this Brand New Intelectron Motion Detector w/ Twin (2) Security Flood light. If after troubleshooting you find that your motion detector light bulb is still not turning off, seek consultation from a security expert. Motion Detector Lights Sometimes Need Resetting After a power surge or other event that affects the electrical in a home, a motion detector light may need to be reset.